Mercury 6 SERIES

CARBURETOR
Page 3B-8 90-857138R1 MAY 2000
Carburetor Disassembly
1. Remove drain screw and drain the carburetor before disassembly.
2. Remove the float bowl.
3. Remove the idle stop screw and pilot jet.
b
a
c
h
d
e
f
g
i
j
a-Drain Screw
b-O-Ring Seal
c-Float Bowl
d-Gasket
e-Screw (2)
f-Pilot Jet
g-Idle Stop Screw
h-Spring
i-Pilot Screw
j-Spring
4. Push out float pin in the direction shown and remove the float.
a
b
c
f
d
e
a-Knurled End of the Float
Pin
b-Pull Out Direction
c-Inserting Direction
d-Float
e-Inlet Needle
f-Float Pin