MID-SECTION
Page 5-8 90-857138R1 MAY 2000
Disassembly
Refer to parts view on page 5A-4 and disassemble mid-section components as required.
Reassembly
Clamp Bracket/Swivel Bracket
1. Install tilt lever spring over tilt lever.
2. Place tilt lever/spring in pocket of swivel bracket.
a
b
c
b
a
56370
56371
a - Tilt Lever Spring
b - Tilt Lever
c - Nylon Bushing Halves (2); Coat I.D. with 2-4-C w/Teflon Marine Lubricant
3. Secure tilt lever/spring to swivel bracket, using plate, lock washers and bolts. Torque
bolts to 70 lb-in. (8 Nm).
4. Secure tilt spring to starboard clamp bracket, using screw and washer.
a
b
d
c
56372
f
e
a - Plate
b - Lock Washer (2)
c - Bolt (2)
d - Tilt Spring
e - Screw
f - Washer
To Next Page
Loading...
