EasyManua.ls Logo

Mercury 60 SeaPro - Propeller Replacement-Standard Gearcase

Mercury 60 SeaPro
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
One anode is installed on the bottom of the transom bracket assembly. The
trim tab is also an anode on the 87.3 mm (3‑7/16 in.) diameter gearcase. The
108 mm (4‑1/4 in.) diameter gearcase has three anodes. One of the anodes is
the trim tab, and the other two anodes are located on each side of the
gearcase.
a - Transom bracket anode
b - Trim tab
c - Anode on each side of gearcase
Propeller Replacement–Standard Gearcase
!
WARNING
Rotating propellers can cause serious injury or death. Never operate the boat
out of the water with a propeller installed. Before installing or removing a
propeller, place the drive unit in neutral and engage the lanyard stop switch
to prevent the engine from starting. Place a block of wood between the
propeller blade and the anti‑ventilation plate.
1. Shift outboard to neutral (N) position.
N
26838
N
29176
3124
c
b
a
MAINTENANCE
58 eng

Table of Contents

Related product manuals