EasyManua.ls Logo

Mercury 92-8M0069603

Mercury 92-8M0069603
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 4 - Maintenance
Page 44 90-8M0113986 eng DECEMBER 2015
3. Remove the air filter element from the air filter housing.
a - Air filter element
b - Air filter housing
Inspection
1. The air filter cannot be cleaned. Replace the air filter if it is dirty or contaminated.
2. Replace the air filter if the foam element is deteriorated or torn.
3.
Replace the air filter at the recommended interval. See Maintenance Schedules for the replacement interval under normal
conditions.
Installation
IMPORTANT: The air filter element is an integral component and must be clean and dry for proper filtration and engine
performance. Do not apply oil to the air filter element.
1. Slide the air filter element onto the air filter housing. Ensure that the element covers all of the holes on the air filter housing.
a - Air filter element
b - Air filter housing
2. Install the air filter housing onto the turbocharger inlet.
3. Tighten the air filter housing clamp to the specified torque.
Description
Nm lb‑in. lb‑ft
Air filter housing clamp 5.6 50
4. Install the oil separator vent hose.
a - Oil separator vent hose clamp
b - Air filter element
c - Air filter housing clamp
53215
a
b
53215
a
b
a
c
b
53217

Table of Contents

Related product manuals