Section 4 - Maintenance
Page 38 90-8M0113986 eng DECEMBER 2015
Add Fluid
1. If necessary, add specified transmission fluid through the dipstick threaded hole to bring the level up to the maximum mark
on the dipstick.
a - Dipstick
b - Maximum fluid level
c - Minimum fluid level
NOTE: Always use the dipstick to determine the quantity of oil or fluid required.
Model
Capacity Fluid type Part Number
Technodrive 485A 2.6 L (2.7 US qt)
SAE 20W ‑ 40 or
SAE 15W ‑ 40 engine oil
Obtain Locally
2. Install the dipstick.
3.
Check the fluid level. Refer to Check Fluid.
Change Fluid
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
1. Remove the fill cap and dipstick.
2. Remove the transmission fluid drain plug and drain the transmission into a suitable container.
a - Fill cap and dipstick
b - Drain plug
3. Dispose of the waste according to local regulations.
4. Reinstall the transmission fluid drain plug.
5. Tighten the drain plug to the specified torque.
Description
Nm lb‑in. lb‑ft
Transmission fluid drain plug 17 150
To Next Page
Loading...
