Section 4 - Maintenance
90-8M0113986 eng DECEMBER 2015 Page 47
6. Install the O‑ring and drain cap on the new water‑separating fuel filter.
Typical
a - Drain cap
b - O‑ring seal
7. Lubricate the fuel filter seals with SAE engine oil 30W.
Typical
a - Water‑separating fuel filter
b - Seals
Tube Ref No. Description Where Used Part No.
80
SAE Engine Oil 30W Water-separating fuel filter sealing ring Obtain Locally
8. Align the filter to the bracket. Twist the filter by hand to secure the filter to the bracket. Do not use a filter wrench.
Typical
a - Water‑separating fuel filter
9. Ensure that the drain cap is securely tightened.
10. Connect the WIF sensor wires, if equipped.
11.
Fill the water‑separating fuel filter with fuel. Refer to Filling.
12. Check the filter and drain cap for fuel leaks.
13. Connect the battery cables.
14. Start and operate the engine. Check the filter connection for fuel leaks. If leaks exist, recheck the filter installation. If leaks
continue, stop the engine immediately and contact your Mercury Diesel authorized repair facility.
To Next Page
Loading...
