Section 2 - On the Water
90-8M0093150 eng MAY 2014 Page 33
5. At the end of the route, input a new waypoint or waypoint route, or take control of the boat. Otherwise, the autopilot reverts
to auto heading mode and continues to pilot the boat on its last heading.
Waypoint Sequence
IMPORTANT: Unlike track waypoint mode, waypoint sequence mode will automatically turn the boat upon arrival at a plotted
waypoint.
1. Turn on the chartplotter and select a waypoint route to be tracked.
2. Place at least one ERC lever into forward. Waypoint sequence mode will not engage if both levers are in neutral or
reverse.
3.
If the track waypoint light is not on, press TRACK WAYPOINT.
4.
Press WAYPOINT SEQUENCE to engage the waypoint sequence mode.
5. VesselView will sound a beep, indicate that the system is in autopilot waypoint sequence, display the compass direction,
and indicate that autopilot is locked bearing to waypoint (BTW).
6. If you are in a waypoint arrival zone set by the chartplotter, waypoint sequence mode only informs the autopilot it is okay to
proceed to the next waypoint. The waypoint sequence mode acts as a waypoint acknowledge function, and the autopilot
sounds a beep when in the zone.
To Next Page
Loading...
Need help?
General
