Section 2 - On the Water
Page 34 90-8M0093150 eng MAY 2014
7. If you are not in a previously set waypoint arrival zone, waypoint sequence mode starts auto sequencing to the waypoints
in the route. Acknowledge that you understand the information presented in the VesselView pop‑up warning, and press the
waypoint sequence button.
8. Stay alert. The boat turns automatically in this mode. You must know if it is safe to turn when the vessel is entering a
waypoint arrival zone. Inform passengers that the boat automatically turns so that they can be prepared.
9. To disable the autosequence mode, press the waypoint sequence button when the boat is not in a waypoint arrival zone.
10. Press the track waypoint button a second time to put the system in standby mode. All lights other than standby turn off.
Cruise Control
The VesselView system features integrated throttle cruise control, which allows the operator to limit the peak RPM of choice
below wide‑open throttle (WOT). This feature requires VesselView. Refer to the owner's manual provided with your VesselView
for operation instructions.
These additional notes are exclusive to your package:
• You can change or disengage cruise control through the screen at any time.
• Cruise control resets when the key is turned off.
• If the cruise limit is changed while the levers are at WOT, the setting gradually changes to the new speed.
• Cruise control does not disengage if the ERC levers are at a higher engine speed than the actual RPM. Bring the levers
back to the forward detent to disengage.
To Next Page
Loading...
Need help?
General
