Section 5 - Maintenance
90-8M0099741 eng JUNE 2015 Page 55
Changing the Oil Filter
1. Use a shop towel to capture oil that may spill. Remove and discard the oil filter.
V-drive model shown
In-line drive model shown
2. Clean up any residual oil that may be on the oil filter mount.
3. Apply engine oil to the sealing ring on the new filter.
4. Install and tighten the oil filter securely following the filter manufacturer's instructions. Do not overtighten.
5. Remove the oil fill cap.
6. Add the required amount of the recommended oil to bring the level up to the bottom of the OK range on the dipstick.
7. With the boat at rest in the water, repeat steps 5, and 6 if necessary.
NOTE: Adding 0.95 L (1 US qt) of engine oil raises the level from the ADD mark to the top of the OK range.
All Models
Capacity Fluid Type
Engine oil (with filter) 4.7 L (5 US qt) Mercury/Quicksilver 25W‑40 Synthetic Blend Engine Oil, NMMA FC‑W
8. Start the engine and operate for three minutes while checking for leaks.
9. Stop the engine and allow the oil to drain into the oil pan for approximately five minutes with the boat at rest in the water.
10. Use the dipstick to check the level of the oil. Add oil if necessary.
Transmission Fluid
Checking the Fluid Level Before Operation
IMPORTANT: Always check the fluid level before starting and operation.
To Next Page
Loading...
Need help?
General