Section 5 - Maintenance
Page 88 90-864197084 NOVEMBER 2008
1. Remove oil fill cap.
6065
IMPORTANT: Add the specified engine oil to bring the level up to, but not over, the full or OK range mark on the dipstick.
2. Add the specified engine oil to bring the level up to, but not over, the full or OK range mark on the dipstick. Recheck oil level.
3. Replace the fill cap.
Engine Model Engine Oil Capacity Fluid type
4.3L (262 cid) 3.8 liters (4 U.S. qt.)
Mercury/Quicksilver Synthetic Blend MerCruiser Engine Oil 25W‑405.0L (305 cid)
4.25 liters (4.5 U.S. qt.)
5.7L (350 cid)
Changing Oil and Filter
Refer to the Maintenance schedule for the change interval. Engine oil should be changed before placing the boat in storage.
IMPORTANT: Change engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil (refer to Specifications).
Easy Engine Oil Drain System
NOTE: Boat must be out of water to perform this procedure.
1. Loosen the oil filter to vent the system.
a - Bilge drain plug
b - Tether
c - Clip
d - Oil drain hose plug
e - Oil drain hose
f - Bilge drain flange
2. Remove the bilge drain plug.
To Next Page
Loading...
