Mercury MerCruiser Axius SeaCore 377 MAG

Section 5 - Maintenance
90-864197084 NOVEMBER 2008 Page 103
8. Install the propeller shaft anode over the propeller shaft nut.
9. Place the flat washer onto the propeller shaft anode screw.
10. Place the star washer onto the propeller shaft anode screw.
11. If a propeller shaft anode is reinstalled, apply Loctite Threadlocker 271 to the threads of the propeller shaft anode screw.
a - Propeller
b - Propeller shaft nut
c - Propeller shaft anode
d - Propeller shaft anode screw
e - Flat washer
f - Star washer
Tube Ref No. Description Where Used Part No.
7
Loctite 271 Threadlocker Propeller shaft threads 92-809819
12. Secure the propeller shaft anode to the propeller shaft using the propeller shaft anode screw and washers. Torque the screw.
Description Nm llb‑in. lb‑ft
Propeller shaft anode screw 38 mm (0.3125‑18 x 1.5 in.) long 27 – 20
Serpentine Drive Belt
Checking
!
WARNING
Inspecting the belts with the engine running may cause serious injury or death. Turn off the engine and remove the ignition key
before adjusting tension or inspecting belts.
a - Alternator pulley
b - Water circulating pump pulley
c - Tensioner pulley and adjustment stud
d - Serpentine belt
e - Steering pump pulley
f - Crankshaft pulley
g - Seawater pump pulley
h - Idler pulley
1. Inspect the serpentine drive belt for the following:
• Excessive wear
• Cracks
a
b
d
c
f
e
5303
33283
h
a
b
c
e
f
g
d