Section 3 - On The Water
Page 68 90-864197084 NOVEMBER 2008
3. If Auto Heading disengaged because the steering wheel was turned, the Resume button light turns on. While the Resume
button light is on, you can press the "RESUME" button to resume the course in Auto Heading. See To Resume a Heading.
If you do not wish to resume the course, press the "AUTO HEADING" button once to engage Standby and press it again to
turn the Auto Heading mode off.
a - Mode indicator—"OFF" or "AUTO"
b - Current heading
c - Drive positions
d - Engine RPM
4. If the ERC Handles were moved to neutral, Auto Heading turns off the "STANDBY" light turns on. You cannot resume your
course by pressing the "RESUME" button. See To Resume a Heading.
5. If Auto Heading disengaged because the "AUTO HEADING" button was pressed, the "AUTO HEADING" button light turns
off and the Standby light comes on. Press the "AUTO HEADING" button a second time and the Standby light goes off, Auto
Heading is disengaged, and the mode is off.
Response Button
1. Press the "RESPONSE" button to change the how hard the selected Axius Premier program tries to keep the boat in position
in the various modes.
a - Indicator lamp
b - "RESPONSE" button
2. Press the "RESPONSE" button again to change the gain further. Each time you press the "RESPONSE" button, the button
light blinks to indicate the gain setting for that mode. The initial button press shows the current setting value. Additional button
presses increase the gain in steps up to three and then return to one.
To Next Page
Loading...
