FUEL INJECTION SYSTEM TROUBLESHOOTING SERVICE MANUAL NUMBER 23
Page 5D-14 90-861326--1 MARCH 1999
Lack of Power, Sluggish or Spongy Symptom (Continued)
6
1. Check for proper fuel pressure while
the condition exists.
•
Refer to
Table A-4 in “General Sys-
tem Diagnostics” section.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to
OBD
System
Check
Go to
Step
7
7
1. Check for injector driver CKT’s 467
or 468 for an open.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to
OBD
System
Check
Go to
Step
8
8
1. Check for proper operation of
Ignition Control (IC) circuit nd the
Knock Sensor (KS) circuit.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to
OBD
System
Check
Go to
Step
9
9
1. Check for proper ignition voltage
output.
•
Refer to
Table A-7 in “General Sys-
tem Diagnostics” section.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to
OBD
System
Check
Go to
Step
10
10
1. Remove spark plugs, check for wet
plugs, cracks, wear, improper gap,
burned electrodes or heavy
deposits.
•
Refer to
“Distributor Ignition Sys-
tem” in “Description and System Op-
eration” section.
NOTE: If park plugs are gas or oil fouled,
the cause of the fouling must be deter-
mined before replacing the spark plugs.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to
OBD
System
Check
Go to
Step
11
11
1. Check ignition coil for cracks or
carbon tracking.
2. If a problem is found, repair as
necessary.
Was a problem found?
-
Go to
OBD
System
Check
Go to
Step
12
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General