21
Chapter 2: Motherboard Installation
Once the AGP card is completely installed under Windows 2000 or Windows
XP, the sign like this “? Video Controller” will pop up below the “Device
Manager” as the following picture shows.
It is normal to see the sign as the onboard VGA card is “Disabled”. Therefore,
users don’t have to worry about this point.
Note: To install the system with an add-on AGP card, you must make sure to
install the driver of add-on AGP card before you install the onboard
VGA driver. If the onboard VGA driver has already been installed before
you install the add-on AGP card, the system will set the onboard VGA
as the primary graphics adapter automatically. In this situation, if you
want to install the add-on AGP card, you need to remove the onboard
VGA driver first, and then install the add-on AGP card and its driver.
PCI1-3 Slots
You can install the 32-bit PCI interface expansion cards in the slots.
CNR Slot
You can install CNR (Communications and Networking Riser) cards including
LAN, Modem and Audio functions, in this slot.
To Next Page
Loading...
Need help?
General
