TROLLING MOTOR INSTALLATION AND OPERATION
10
Transom Mount Installation
NOTE: Fits up to 3‑1/4 in. thick transoms.
1. Select an appropriate area on the transom of the boat to install the
mount.
2. Retract the transom clamp screws.
3. Place the transom mount over the transom of the boat. Ensure the
mount is securely positioned.
4. Tighten the transom clamp screw securely.
IMPORTANT: Overtightening the transom clamp screws can weaken
or damage the mount bracket.
Stowing and Deploying the Trolling Motor
!
WARNING
Rotating propellers can cause serious injury or death. Never start or
operate the motor out of water.
STOWING THE MOTOR
!
CAUTION
Moving parts, such as hinges and pivot points, can cause serious
injury. Keep away from moving parts when stowing, deploying, or
tilting the motor.
To Next Page
Loading...
Need help?
General