6. Apply clean oil to the new sealing O‑rings.
a - Filter cover
b - O‑ring
c - Oil filter element
d - Pin with O‑ring
7. Install the new oil filter element into the filter housing.
IMPORTANT: When installing the oil filter element, ensure that the pin on the lower end of the filter element is aligned with
the hole in the housing.
a - Hole
8. Install the cover onto the filter element. Tighten the cover to the specified torque.
Description
Nm lb‑in. lb‑ft
Oil filter element cover 35 – 25.8
9. Clean up any spilled oil and dispose of as directed by local authorities.
10. Remove the oil fill cap and add the required amount of oil to the engine.
IMPORTANT: When adding oil to the engine, always use the dipstick to determine how much oil is required.
Sterndrive Gear Lube
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
Checking
NOTE: The gear lube level will fluctuate during operation. The gear lube level should be checked with the engine cold, before
starting.
Section 4 - Maintenance
Page 46 90-8M0145546 eng MAY 2018
To Next Page
Loading...
Need help?
General