Merlin M2000PE - Page 10

05/04
10
h) Press VAL to confirm. The lower bound will now be displayed again, e.g. 0.020
i) Pass the lowest serial number card or tag through the reader once, e.g. serial
no. 12350. All decimal points will display if the first code is successfully as-
signed, e.g. 0.0.2.0.
j) Press VAL to confirm. Display will return to the function selection menu.
k) Simultaneously press INC & DEC to exit programming mode.
All remaining cards or tags should now be automatically sequentially assigned to locations.
F7: Block erase
To erase a block of codes from memory.
a) Simultaneously press INC & DEC to enter programming mode.
b) Press FUN to access the function selection menu.
c) Scroll using INC & DEC to display F7.
d) Press VAL to confirm. The lowest required location for deletion will appear on
the display. (Default is 0.001) Note the left decimal point is on, indicating that
this location is the lower bound of the range.
e) If required, scroll using INC & DEC to alter the lowest location to be deleted, e.g.
0.020
f) Press VAL to confirm. The highest location for deletion will appear on the dis-
play. (Default is 0001.) Note the right decimal point is on, indicating that this
location is the upper bound of the range.
g) Scroll using INC & DEC to display the highest location for deletion, e.g. 0029.
h) Press VAL to confirm. The letter C will be displayed.
i) Press VAL again to confirm the block erase. Codes in all locations from the
lower to the upper selection will be deleted. Display will return to the function
selection menu.
j) Simultaneously press INC & DEC to exit programming mode.
F8: Erase all
Codes can be erased from all locations. However this will not affect other stored param-
eters such as relay times or channel assignments.
a) Simultaneously press INC & DEC to enter programming mode.
b) Press FUN to access the function selection menu.
c) Scroll using INC & DEC to display F8.
d) Press VAL to confirm. The letter C will be displayed.
e) Press VAL again to confirm the bulk erase. Codes in all locations will be deleted.
Display will return to the function selection menu.
f) Simultaneously press INC & DEC to exit programming mode.
F9: Data copy
Codes may be transferred serially in blocks from locations in one M2000PE to the same