05/04
3
Introduction
The M2000PE is an access controller for the operation of two doors.
It has an integrated Merlin high security code hopping radio receiver. It also has two Wiegand
inputs for external readers, and two 9 V dc outputs to power them.
Two output relays, each with a 5-amp capacity, allow direct connection to electric locks.
An enabling link on the relays further allows either output to be controlled by one or two
simultaneous inputs, for selected management of either person plus vehicle or personnel
only.
An anti-pass back option allows for exit control management,
A 4-digit LCD display is used for programming and assigning readers or transmitters to a
total memory capacity of 2000 users. The LCD momentarily displays the assigned code
on each valid access.
Connection to the serial port of a PC running WIN-GT/SYSTEM software is possible
using the INT485C adapter. This allows the remote entering or deletion of either individual
or blocks of serial numbers. Alternatively, the handheld GT/SYSTEM terminal can be used.
Four buttons, with colour ID and the aid of the LCD display, offer easy to use setup, pro-
gramming, and parameter setting.
All settings can be password protected.
The M2000PE is housed in a plastic enclosure suitable for indoor installations and for
DIN rail mounting.
Radio interference
Radio interference can reduce the performance of radio frequency (RF) remote controls.
RF remote controls are required to operate in shared radio frequency bands. Regulations
permit other users to continuously operate higher powered devices such as baby monitors
or wireless headphones in these shared bands. These devices may cause radio interfer-
ence that reduces the performance of your remote control. Switch off interfering devices
if possible.
To Next Page
Loading...
