Page 8 of 15
Standard Operation
Powering up the Unit
Power up the Remote User Interface by momentarily pressing the power button. The
power button is the round orange button as shown below:
The screen should light up, and you should see the Merrick identification screens
followed by the Connection Menu (see below).
Powering down the Unit
Turn off the Remote User Interface by pressing and holding the power button until the
display goes blank. This takes 1- 2 seconds. You will see a “powering down” graphic
while the unit powers down. Note: Powering down the unit disconnects the Bluetooth
connection if there is one.
Connection Menu
When powered up, you should see the Connection Menu. This menu allows you,
using the Bluetooth protocol, to find and connect to the correct Merrick Feeder and/or
to manage the stored list of feeders utilizing one of the following options:
To Next Page
Loading...
Need help?
Operating Environment
Power
