Merrychef eikon e2s - Page 100

9 Cleaning procedures
eikon e2s Installation and Operating Manual CE 100
5.
For difficult areas, leave to soak for 10 minutes with the appliance
door open.
Use a non-abrasive nylon scrub pad/sponge to clean all surfaces
of the cavity and the inside surface of the appliance door.
NOTICE: Do not scrub the roof (jet plate) or door seal or use
metallic scourers.
6.
Wash off all surfaces using a wet clean cloth.
Dry using a fresh, clean cloth or paper towel.
If required the cavity roof and door seal can be wiped clean with a
wet clean cloth as well.
7.
Replace the cleaned cook plate / wire rack.
Double-check that all components are dry before re-fitting them.
8.
Close the appliance door.
9.
Wipe the outside of the appliance with a damp cloth.
NOTE: Do not use the appliance without a clean air filter in place.
10.
Press the green tick to continue.