J
K
L
M
USB oven programs (J)10.8
IMPORTANT: Downloading from a USB will clear
all the existing programs.
Check that the key has the correct number/code
for the programs you want to load into the oven
memory.
Select USB from the settings screen.10.8.1
Slide the USB cover (logo on the oven front) 10.8.2
upwards to insert the USB into the slot.
When the inserted USB stick has nished 10.8.3
ashing, select the required USB symbol, for example;
RECIPES.
Select the new le using the scroll arrows if 10.8.4
required to locate the le. Note; a tinted band over a
le name indicates the le is not available to use.
Double check the le is correct before selecting 10.8.5
OK, if not, select ‘X’ and locate the correct le.
Progress of the le update is displayed. Once 10.8.6
completed the oven restarts and commences heating
up to the PREHEAT temperature ready to cook.
Remove the USB and keep in a safe place. 10.8.7
Reposition the USB cover.
Restore Factory Defaults (K)10.9
Select the factory symbol to replace the existing 10.9.1
oven settings with the original factory default settings.
Note; this action cannot be undone.
Select OK, or select the red cross to cancel and 10.9.2
keep the existing settings.
Temperature Band (L)10.10
Select the ‘Temp Band’ symbol at which the 10.10.1
oven controls i.e. ±10°C.
Select the required temperature band 10.10.2
checkbox, shown by a green tick. Note; although the
lowest practical Temp Band should be used, if the
set oven temperature falls by more than the selected
Temp Band, the ready to cook mode and Temp Band
are deactivated until the oven reaches the preheat
temperature.
Change Password (M)10.11
Select the key symbol to change the oven 10.11.1
passwords.
Select the oven Settings or Service symbol.10.11.2
Enter the existing password and select OK to 10.11.3
conrm.
Enter the new password, select OK.10.11.4
Conrm new password, select OK.10.11.5
To Next Page
Loading...
Need help?
General
