29
Emergency deactivation is also possible with the alarm system by entering the OVERRIDE CODE using the Push button/
LED or alternatively using the electronic keys.
For some vehicles emergency deactivation is available using the original car key with transponder.
To know on which car models the EMERGENCY DEACTIVATION with original transponder is available, refer to the product/
car list on the HYPERLINK www.metasystemcorporation.com.
EMERGENCY DEACTIVATION
The control unit is supplied with a customized OVERRIDE CODE and
you can nd it on the “Factory code” sticker a xed on the control
unit itself. This means you do not have to customize it yourself. AFFIX
the “Factory code” sticker on the OVERRIDE CARD which is in
the pack; for its use please follow the instructions given in the user
handbook. If you want to change the OVERRIDE CODE, do so using
the PRG007 PROGRAMMER.
OVERRIDE CODE
In some of the CAN-BUS and LINBUS protocols available for the META EVOCAN product, the emergency function with
transponder is available. This function makes it possible to avoid the use of additional electronic keys by exploiting the
recognition of the transponder chip included in the original remote control.
To deactivate the alarm in emergency condition, simply activate the instrument panel using the original key and wait a
few moments until the transponder chip is recognized.
EMERGENCY DEACTIVATION USING THE TRANSPONDER OF THE ORIGINAL REMOTE CONTROL
If the function is enabled, to verify the engine immobilizer protection by simulating an attempt to start with the
product inserted, it is necessary to shield or remove the transponder from the car key to prevent the product
disarming and consequently the engine immobilizer protection exclusion.
The deactivation function by transponder is present in many product CAN-BUS protocols META
EVOCAN and the information for tting on individual vehicles are available ONLINE on website
www.metasystemcorporation.com in the CAR-ALARM technical area.
To Next Page
Loading...
