MetaSystem Metafer - Instructions for Use - Scan Results and Exiting; Relocating Objects and Loading Scans; Exiting Metafer and Neon

Quick Guide
12
the object coordinates. Values of search parameters are displayed in the gallery images
according to mode and classifier used.
a To relocate an object just click left on the corresponding gallery image. Switch to an
objective with higher magnification, if necessary.
a To load a previous search run, right click on the slide position (in Relosys: the first) and
then select the desired slide in the ‘Open’ dialog box.
a If Ikaros or Isis is installed on your Metafer / Relosys system, you can start the program
by a left click on the corresponding command button (see above).
a You can quit the Metafer / Relosys with a left mouse click on the “Exit” button.
a Without Neon:
s Print a report by clicking the ‘Print Reports’ command in the ‘Slide’ menu.
s Save scans ‘File – Save Slide’.
s You can exit the program by selecting ‘File – Exit’.
a With Neon:
s Press the key combination [Alt] + [Tab] to bring Neon to the front.
s Add ‘Cell Data’ by clicking on the respective icon in the sidebar or add case data by
clicking the ‘Data’ view tab.
s Print a report by clicking on the ‘Report’ icon in the Neon header and select the
wanted report template.
s Exit Neon and Metafer by clicking on the ‘Main’ icon in the Neon header, followed
by click on the ‘X’ (Exit) icon in the headline of the Neon program window.