Metos Master LUX 60-EL

Questions and Answers

S
Sandra NewtonAug 14, 2025
What to do if Metos Dishwasher does not load water?
- W
  williamcherryAug 14, 2025
  If your Metos Dishwasher isn't loading water, here are a few things to check: * Make sure the water supply cock is open; if it's closed, open it. * Inspect the spraying arm nozzles for clogs; clean them along with the pipes. If the machine is clean, check the salt or carry out regeneration more frequently. * Check the solenoid valve filter for sand clogs; clean the filter if necessary. * Consider a faulty pressure switch; replace the pressure switch if needed.
B
Bradley BakerAug 17, 2025
Why does my Metos Master LUX 60-EL suddenly stop during operation?
- A
  Ashley OlsenAug 17, 2025
  If your Metos Dishwasher suddenly stops during operation, it could be due to: * Connection to an overload system: Connect the machine separately (call the authorized personnel). * A triggered safety device: Check the safety devices (call the authorized personnel).
N
ncordovaAug 21, 2025
Why does Metos Master LUX 60-EL Dishwasher stop and replenish water during wash?
- R
  Robert WrightAug 21, 2025
  If your Metos Dishwasher stops and replenishes water during the wash phase, consider the following: * The previous day's water was not changed: Empty the tank and carry out a new filling. * Temperature of water in tank too high: Have the thermostat and pressure switch checked by the Assistance Centre. * Overflow incorrectly positioned: Remove and correctly position the overflow.
M
morenosharonAug 29, 2025
Why are pots and dishes not drying properly in my Metos Master LUX 60-EL Dishwasher?
- D
  Denise WilliamsAug 29, 2025
  If your pots and dishes aren't drying properly in your Metos Dishwasher, it could be due to several reasons: 1. Insufficient rinse aid dosage: Increase the amount by adjusting the dispenser screw. 2. Unsuitable basket: Use a suitable basket that allows the pots to be tilted so that the water runs off. 3. Leaving dishes inside for too long: Remove the basket immediately after the wash cycle to allow air drying. 4. Rinse water temperature: Ensure the rinse water temperature is at least 80°C by checking the boiler thermostat. 5. Cold water feed: If the machine is fed with cold water, use the long cycle.
A
Ana SantosSep 1, 2025
How to remove streaks and smears from dishes in Metos Master LUX 60-EL?
- A
  Allison NguyenSep 1, 2025
  To remove streaks and smears on pots and dishes from your Metos Dishwasher, consider these points: * Reduce rinse aid concentration using the dispenser screw if it's too high. * Check your water quality; ensure water hardness doesn't exceed 10°f. * For machines with a purifier, ensure sufficient salt in the container and correct resin regeneration; fill the salt container with coarse salt. * If there's salt in the machine tank, thoroughly clean and rinse the machine, avoiding spillage when filling the salt container.
V
vsampsonSep 5, 2025
What to do if booster pump can't prime in Metos Dishwasher?
- T
  Tracy Fritz DDSSep 5, 2025
  If the booster pump in your Metos Dishwasher can't prime, it might be due to little pressure on feeding. In this case, take out the boiler pipe and drain the pump.
J
justin88Sep 9, 2025
Why Metos Master LUX 60-EL doesn't wash and the pump is noisy?
- J
  Justin HolmesSep 9, 2025
  If your Metos Dishwasher isn't washing and the wash pump is noisy (on machines with a three-phase pump), the pump direction may be inverted due to incorrect power cable connection. Check and correctly connect the cable wires.
C
christinedavisNov 24, 2025
How to improve washing results in Metos Master LUX 60-EL?
- L
  Luis NguyenNov 24, 2025
  To improve washing results with your Metos Dishwasher, consider these points: * Ensure the washing nozzles aren't clogged; unscrew and clean them, along with the rotation shaft, refitting them correctly. * Adjust detergent concentration if it's too low. * Clean dirty filters by removing and brushing them under running water before refitting. * If there's foam, use a non-foaming detergent and check the rinse aid dosage. * For fats or starches, ensure adequate detergent concentration. * Check the tank temperature, it should be between 50°C and 60°C. Adjust the thermostat or heating element if needed. * For heavy soiling, select the longest cycle or repeat the wash cycle. * If the washing water is too dirty, drain the tank, clean the filters, refill the tank, and correctly re...