EasyManua.ls Logo

Metos HOOD 110 - User Manual

Metos HOOD 110
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
HOOD TYPE MACHINE
TYPE: HOOD 110, HOOD 110-I, HOOD 800
Installation and Operation Manual
S/N:

Questions and Answers

  • K
    Kathy MyersAug 18, 2025
    Why are there streaks or smears on my Metos HOOD 110 Dishwasher's pots and dishes?
    • C
      calvin50Aug 18, 2025
      Streaks or smears on your dishes from the Metos Dishwasher can stem from a few issues. First, the rinse aid concentration might be too high; reduce it using the dispenser screw. Second, the water might be too hard; ensure it's no more than 10°f. If you have a machine with a purifier, check the salt level in the container and regenerate the resins more frequently. Finally, ensure no salt has spilled into the machine tank; if so, thoroughly clean and rinse the machine.
  • S
    steven96Aug 21, 2025
    What to do if my Metos HOOD 110 Dishwasher does not load water?
    • C
      crystal66Aug 21, 2025
      If your Metos Dishwasher isn't loading water, check these items: 1. Make sure the water supply cock is open. 2. Inspect the spraying arm nozzles for clogs and clean them along with the pipes. 3. Check the solenoid valve filter for sand and clean it if necessary.
  • C
    Christina WrightAug 25, 2025
    What to do if my Metos HOOD 110 doesn't start?
    • R
      Ronald MarshAug 26, 2025
      If your Metos Dishwasher isn't starting, the first thing you should check is whether the main switch is turned off. If it is, simply turn the switch on.
  • L
    Leah ParkerAug 28, 2025
    Why are pots and dishes not properly dried in my Metos Dishwasher?
    • R
      Roberto WilsonAug 28, 2025
      If your Metos Dishwasher isn't drying dishes well, consider these points: * The rinse aid dosage may be insufficient; increase it by adjusting the dispenser screw. * The basket may not be suitable, preventing water from running off; use a more appropriate basket. * Dishes left inside the tank for too long will not dry efficiently; remove them immediately after the cycle. * The rinse water temperature may be too low; it should be at least 80°C, so check the boiler thermostat. * If the machine is fed with cold water, use the long cycle.
  • A
    Abigail PayneAug 31, 2025
    What to do if my Metos Dishwasher stops suddenly during operation?
    • B
      bishopjasonAug 31, 2025
      If your Metos Dishwasher suddenly stops during operation, it might be due to the machine being connected to an overload system. Connect the machine separately.
  • T
    Thomas NguyenSep 3, 2025
    What to do if my Metos Dishwasher stops and replenishes water during the wash phase?
    • M
      mstanleySep 3, 2025
      If your Metos Dishwasher stops and replenishes water during the wash phase, the previous day's water may not have been changed; empty the tank and refill it. Also, the overflow may be incorrectly positioned; remove and correctly position the overflow.
  • C
    cassandrawrightSep 7, 2025
    What to do if the booster pump can't prime in my Metos HOOD 110?
    • J
      jeremybutlerSep 7, 2025
      If the booster pump in your Metos Dishwasher can't prime, try taking out the boiler pipe and draining the pump.
  • N
    Nicholas TurnerSep 12, 2025
    What to do if my Metos HOOD 110 Dishwasher does not wash and the wash pump is noisy?
    • A
      April PughSep 12, 2025
      If your Metos Dishwasher isn't washing and the wash pump is noisy (on machines with a three-phase pump), the pump direction may be inverted due to an incorrect power cable connection. Check and correctly connect the cable wires.
  • M
    monique75Nov 14, 2025
    What to do if my Metos Dishwasher has inadequate washing results?
    • S
      sheila18Nov 14, 2025
      If your Metos Dishwasher isn't cleaning dishes properly, several factors could be at play. Start by checking if the washing nozzles are clogged or the washing arms aren't turning; if so, unscrew and clean the nozzles and rotation shaft, then correctly refit them. Ensure that you are using enough detergent. Clean the filters with a brush under running water and replace them. If there's excessive foam, switch to a non-foaming detergent or reduce the amount you're using, and check the rinse aid levels. The tank temperature should be between 50°C and 60°C; adjust the thermostat or inspect the heating element if needed. For heavily soiled items, select a longer wash cycle or repeat the cycle. Lastly, if the washing water is too dirty, drain the tank, clean the filters, refill the tank, and repl...

Summary

General Safety Instructions

Important Safety Precautions

Crucial safety advice and warnings for operating the dishwasher, including electrical and operational safety.

INSTALLER SECTION

1. MACHINE INSTALLATION

Covers the initial steps for setting up the dishwasher, from receiving to water connection.

1.2 Water connection

Details on connecting the water supply, including pressure requirements and softener advice.

1.3 Electrical connection

Guidelines for safe and compliant electrical hook-up of the dishwasher.

USER SECTION

3. OPERATION

General procedures for operating the dishwasher, including starting cycles and filling the tank.

4. MAINTENANCE

Procedures for maintaining the dishwasher to ensure optimal performance and longevity.

4.1 Routine maintenance

Daily cleaning tasks, including filter cleaning and wash arm checks.

8. TROUBLESHOOTING (MACHINE PROBLEMS, CAUSES AND CURES)

A comprehensive guide to diagnosing and fixing common issues with the dishwasher.

Metos HOOD 110 Specifications

General IconGeneral
BrandMetos
ModelHOOD 110
CategoryDishwasher
LanguageEnglish

Related product manuals