Metos Master AQUA 50 - User Manual

Other manuals for Metos Master AQUA 50

Instructions For Use And Maintenance23 pages

Questions and Answers

C
Christina FreemanAug 8, 2025
Why are glasses or dishes not completely dry in my Metos Dishwasher?
- B
  Bruce AustinAug 8, 2025
  If your Metos Dishwasher isn't drying dishes completely, it could be due to several reasons: * Insufficient rinse aid. Increase the amount of rinse aid by adjusting the screw on the dispenser. * The rack being unsuitable. Use a suitable rack that allows dishes to be tilted for water run-off. * Dishes left too long in the tub. Remove the rack as soon as the cycle stops for quicker air drying. * Rinse water temperature being too low (less than 75 °C - 80 °C). Check the boiler thermostat temperature. * Dishes and glasses having a rough or porous surface. Consider replacing them.
Z
Zachary WoodAug 16, 2025
What to do if my Metos Dishwasher does not draw water?
- P
  perezlauraAug 16, 2025
  If your Metos Dishwasher isn't drawing water, check the following: 1. Ensure the water tap is open. 2. Clean the rinsing arm nozzles, pipes, and electrovalve filter if they are clogged or have lime deposits. If your machine has a water softener, check the salt content or regenerate the resins more often. 3. If the pressure switch is faulty, it will need to be replaced by a qualified technician.
J
jessica74Aug 25, 2025
How to eliminate foam in Metos Dishwasher?
- V
  valerie98Aug 25, 2025
  If you notice foam in your Metos Dishwasher, it could be due to: * Using unsuitable products. Switch to a non-foaming detergent or use less of your current detergent. * The tub temperature being too low. Adjust the thermostat or check the heating element.
J
Jeffery WhiteOct 31, 2025
How to fix unsatisfactory washing results in my Metos Master AQUA 50 Dishwasher?
- M
  mreedOct 31, 2025
  If your Metos Dishwasher is producing unsatisfactory washing results, there are several potential causes: * The washing nozzles might be clogged, or the washing arms might not be rotating. In this case, unscrew and clean the nozzles and the rotating column, then refit them correctly. * There could be unremoved grease or starch, indicating that the detergent concentration is too low. * The filter might be too dirty. Remove the filter, clean it under running water with a brush, and refit it. * The tank temperature might be incorrect (it should be between 50 °C and 60 °C). Adjust the thermostat or check the heating element. * The washing cycle might be too short for the grime build-up. Choose a longer cycle or repeat the wash cycle. * The wash water could be too dirty. Empty the ...