REV. 4/5/2018 INST95-6546B
3
(Figure A)
1. Secure the
radio brackets
to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Secure the radio assembly to the dash
using the factory screws.
4. Snap the
radio trim panel
over the radio
assembly to complete the installation.
KIT ASSEMBLY
To Next Page
Loading...
