Metra Electronics 99-3010S User Manual

CAUTION! All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
Metra. The World’s Best Kits.
®

MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/25/18 INST99-3010S
INSTALLATION INSTRUCTIONS
99-3010S
KIT FEATURES
• DIN radio provision with pocket
• ISO DIN radio provision with pocket
• ISO DDIN radio provision
• Painted silver to match the factory finish
KIT COMPONENTS
• A) Radio trim panel with climate controls • B) Radio housing • C) Pocket • D) ISO DDIN brackets • E) ISO DDIN trim plate • F) ISO trim plate
• G) ISO brackets • H) Axxess interface and harness (not shown)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 9/32” socket wrench • T-20 Torx screwdriver
• Cutting tool
TABLE OF CONTENTS
Dash Disassembly ...............................................2-3
Kit Preparation .......................................................3
Kit Assembly
–DIN radio provision with pocket ........................4
–ISO DIN radio provision with pocket ..................4
–ISO DDIN radio provision .....................................5
Axxess Interface Installation .................................6
WIRING & ANTENNA CONNECTIONS
Wiring Harness: Axxess interface included
Antenna Adapter: 40-EU55 (sold sep.)
Steering wheel control interface: ASWC-1 (sold sep.)
Backup camera retention: BACKUPCAM-2 (sold sep.)
A B C E
G
D
F
Chevrolet Camaro 2010-2015
■

Metra Electronics 99-3010S Specifications

General

Color	Silver
Material	Plastic
DIN Installation	Yes
ISO Installation	Yes
Compatible With	Select vehicle models

Summary

Dash Disassembly

Kit Preparation

Kit Assembly

DIN radio provision with pocket

Instructions for installing a single-DIN radio with a pocket.

ISO DIN radio provision with pocket

Instructions for installing an ISO-DIN radio with a pocket.

ISO DDIN radio provision

Instructions for installing an ISO-DDIN radio.

Axxess Interface Installation

Connections to be Made

For models without an amplifier

Specific wiring instructions for vehicles without a factory amplifier.

For models with an amplifier

Specific wiring instructions for vehicles with a factory amplifier.

12-pin pre-wired ASWC-1 harness

Instructions for connecting the ASWC-1 harness for steering wheel controls.

DIN jack

Using the DIN jack to retain the personalization menu.

Installing the Interface

Programming the Interface

Programming the climate display

Steps to re-program the climate display if power is lost.

Adjusting the Interface

Chime level adjustment

Procedure to set the audible warning chime volume.

OnStar level adjustment

Procedure to set the OnStar audio volume level.

Troubleshooting

Resetting the Axxess interface

Steps to reset the Axxess interface module to its default state.

Configure Backlight Color

Final Assembly