5
Kit Assembly 99-7335S
1. Cut and remove the center bar from the
radio housing. (Figure A)
2. Snap the double DIN brackets to the
inside edge of the double DIN trim plate.
(Figure B)
3. Slide the double DIN radio into the
bracket/radio housing assembly and
secure the double DIN radio to the
assembly using the screws supplied
with the radio. (Figure C)
4. Snap the double DIN trim plate into the
radio housing. (Figure C)
5. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
6. Reassemble dash in reverse order
of disassembly.
Double DIN radio provision
(Figure C)
(Figure A)
(Figure B)
To Next Page
Loading...
