Metra Electronics 99-7343 - Kit Assembly Procedure; Assembling A;C Vents and Trim; Mounting Hazard Switch and Display

5
Kit Assembly
99-7343
(Figure B)
(Figure A) (Figure C)
1. Snapthea/cventsintothea/cvent
 trimpanels.(FigureA)
2. Attachtheleftandrighta/cventtrim
panels and the climate controls to
 themainradiohousingpanelusingthe
 provided(10)#8X1/2”Phillipsscrews
 and(2)#8X1/4”Panheadscrews.
 (FigureB)
NOTE: #8X1/4” Pan head screws
must be installed in the
indicated locations.
3. Snapthehazardswitchintothemain
 radiohousing.(FigureC)
Continued on next page