Metrix OX 832 - Symbols; Instructions; Guarantee; Maintenance and Metrological Verification

30 MHz-differential oscilloscope
4
1.1.3. Symbols
Refer to the user's manual.
Incorrect use may result in damage
to the device or its components.
Risk of electric shock
Ground
1.1.4. Instructions
- Before opening the apparatus, always disconnect it from the mains power supply
and measurement circuits, and make sure that you are not charged with static
electricity which could damage internal components.
- Any repair, maintenance or adjustment of the oscilloscope when it is powered may
only be done by qualified personnel, after reading the instructions in this manual.
- A "qualified person" is a person who is familiar with the installation, construction
and use and the dangers present. He is authorized to switch the installation and
equipment on and off in accordance with the safety rules.
- Take care not to obstruct ventilation holes when using the apparatus.
1.2. Guarantee
This oscilloscope is guaranteed against any material defect or manufacturing vice in
accordance with the general conditions of sale.
During the guarantee period (2 years), the apparatus may only be repaired by the
manufac-turer, and the manufacturer will be free to decide to repair or replace all or
part of the apparatus. The guarantee conditions state that the manufacturer will pay
for return transport.
The guarantee is not applicable in the following cases:
1. any improper use of the equipment or if it is used in association with incompatible
equipment;
2. modification of the equipment without explicit authorization by the manufacturer’s
technical departments;
3. work done by a person not approved by the manufacturer;
4. adaptation to a specific application not included in the definition of the equipment
or by the operating instructions;
5. a shock, drop or flooding.
1.3. Maintenance and metrological verification
Return your instrument to your distributor for any work to be done within or outside
the guarantee.
1.4. Servicing
Clean the instrument with a wet cloth and soap. Never use abrasive products or
solvents.
Some internal capacitors may retain a dangerous potential, even after the apparatus
has been switched off.