3
INSTALLATION AND SET-UP
1. Check for Shipping Damage: Check the packaging and cabinet for shipping damage after unloading the unit,
and after removing all the packaging.
2. The receiver of this product is responsible for filing freight damage claims. This equipment must be opened
immediately for inspection. All visible damage must be reported to the freight company within 48 hours and must
be noted on freight bill at the time of delivery.
3. Concealed damage is your responsibility — you must advise the carrier of any loss or damage within 15 days
after receipt of the cabinet. If there is damage, retain the original packaging for inspectors.
4. After unpacking the cabinet, remove all tape and packing material from the inside as well as outside of the unit.
5. Any protective covers (plastic or paper sheet) on the sheet metal or clear door, if applicable, must also be
removed before turning the cabinet on.
WARNING: Only factory approved service agents should attempt to service, repair or replace electrical
components, wiring or the power cord.
6. Refer to the data plate at the lower rear of the cabinet for the electrical specifications. With the power switch off,
plug the cord into a 125 VAC, 60 cycle, grounded receptacle. Cabinets rated at 2000 watts must be plugged
into a 20-amp receptacle and must be used on an individual branch circuit. Cabinets rated at 1440 watts may be
plugged into either a 15 amp or a 20-amp receptacle.
15 Amp Outlet
For 1440 Watt Cabinets
20 Amp Outlet
For 2000 Watt Cabinets
(1440 watt cabinets can be
plugged into 20 Amp outlet)
CAUTION: A 3 Series cabinet (polymer Insulation Armour panels on the sides, top and rear) must not be placed
next to char broilers. Allow 18" (46cm) between the Insulation Armour and any cooking equipment. Do
not allow hot kitchen equipment whose surfaces exceed 200°F (90°C) to touch the panels.
WARNING: Do not allow combustible materials to be stored or accumulate on, under or next to the cabinet.
Do not block any ventilation louvers or slots.
NOTE: Temperature is displayed °F.
120 volt
To Next Page
Loading...
Need help?
General
