1-800-325-9103
PB-SXI - 37 - www.meyermfg.com
Grease (2) PTO input shaft bearings. The bearings are accessible on the left side of the PTO cover shield.
Grease (6) bearings on the right hand side drive shaft. The front and second
bearings are grease line fitted to the
right front side grease bank. The remaining rear
bearings are located along the right hand side of the spreader tank. The
zerks are accessible through the steel shielding.
Grease (2) tandem wing pivots. Over greasing is not possible
.
Grease (2) rear gate slide guides. Grease the slide guides from the top side with the rear gate opened
. Allow
grease to lubricate rear gate ends and slide guide surfaces. In freezing weather, dump used motor oil down each slide
guide once a week or more often if needed. Over greasing is not possible
.
Grease (1) integral overrunning clutch on the spinner transfer shaft connection to the corner gearbox.
L11
L17
L10
L3
L13
L18
L2
L19
L16
L14
L21
L20
L12
L20
L11
L13
L5
L4
L5
L4
SHIELDS REMOVED FOR ILLUSTRATIVE
PURPOSES ONLY.
To Next Page
