Meyer Manufacturing Corporation - 36 - PB-SXI
8.1.2 Daily Lubrication (every 8-12 loads)
Grease (2) rear spinner lower bearings. The bearings are grease line fitted to the left rear frame channel of the
spreader.
Oil (4) roller chain drives with automatic oiler at the front of the spreader with clean 30 weight oil. The roller chains
are accessible by opening the front steel shielding cover.
Grease (5) bearings supporting the two large jack shaft reduction sprocket weldments and the third auger drive
shaft on the front drive. The zerks are accessible by the right front side and left front side grease banks of the spreader.
Be careful not to over grease
.
Grease (2) auger shaft bearings. The bearings are grease line fitted to the lower zerks on the right front side and
left front side grease banks of the spreader. Over greasing is not possible
.
8.1.3 Weekly Lubrication (every 25-30 loads)
Grease the CV center housing until it is evident around
the center sliding disk (CV gets greased through the cross and
bearing).
Grease the cross and bearings until it is purged around
the seals.
Grease telescoping members until it adequately covers
the sliding members. Take apart occasionally to make sure
adequate lubrication is being added. Take apart each season to be cleaned with solvent and re-coated with grease
before re-assembling.
Add 2-3 pumps of grease to the shield bearings.
Check regularly for any lubricant leakage of the front gearbox and the
(3) gearboxes at the rear of the spreader. See L16 & L19 under
Monthly Lubrication.
To Next Page
