MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
COMMAND SUMMARY
Command Paramete
r
Default Mode Function Page
8BITCONV
ON|OFF off Packet Enables transmission of 8-bit data in
converse mode
6-5
8LEVELS
ON|OFF off FAX/SSTV Enables MFJ-1278B to operate 8 gray
levels in FAX and SSTV modes.
6-5
16LEVELS
ON|OFF on FAX/SSTV Set MFJ-1278B to transmit and to receive
16-gray levels FAX and SSTV.
6-6
AALT
ON|OFF off AMTOR Enables the alternate SELCALL set by the
ALTCALL command in mode A ARQ.
6-6
ABORT
-- I-command M-Packet Allows SYSOP to force a disconnect on
the Mailbox link.
6-6
ACKPRIORITY
ON|OFF on Packet Permits an acknowledging TNC to trans
mit without regard to slotting delay.
6-7
ACKTIME
n 14 Packet Controls a delaythat occurs whenever any
packets thathavebeen received are not
addressed to that unit.
6-7
ALOCKCHAR
nn $15 (^U) CW/MCW Character used to force the MFJ-1278B to
match its transmit speed to that of the
incoming signal.
6-8
ALTCALL
ssss blank AMTOR Sets an alternate SELCALL that the MFJ-
1278B responds to in AMTOR mode A.
6-8
ANSBSTR
cccc blank AMTOR Enables the MFJ-1278B'sresponse to
a"Who Are You?".
6-8
ANSWRQRA
ON|OFF on Packet Set MFJ-1278B to polls all TNCs within
range.
6-9
ARCVCHAR
nn $12 (^R) RTTY/CW/ Specifies the character used to ASCII
return to receive after transmitting.
6-10
ARQ
ssss I-command AMTOR Initiates mode A "ARQ" connection. 6-10
ASA
-- I-command RTTY/ASCII/AMTOR/
Packet
Invokes MFJ-1278B to analyze incoming
signals.
6-10
ASENDCHA
nn $14 (^T) RTTY/CW/ASCII Specifies the transmit character. 6-11
ASPECT
n 3 FAX Sets a reasonable aspect ratiobetween the
Hor/Ver. representation of the FAX
picture.
6-11
AUTOBAUD
ON|OFF on All Enables the autobaud function which
matches MFJ-1278B terminal baud rate
to terminal program baud rate.
6-12
AUTOLF
ON|OFF on Packet Determines the way the <CR> characters
are displayed.
6-13
AUTOTRAC
ON|OFF on CW/MCW Automatically locks onto the incoming cw
signal and displays the speed.
6-14
AWLEN
n 8 All Defines the word length used by the MFJ-
1278B's RS-232 port.
6-15
AX25L2V2
ON|OFF on Packet Determines the use of AX.25 Level 2 Ver.
2 or Ver. 1 Protocol.
6-15
To Next Page
Loading...