EasyManua.ls Logo

MFJ Multi-mode Data Controller MFJ-1278B - Page 361

MFJ Multi-mode Data Controller MFJ-1278B
406 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
Command Paramete
r
Default Mode Function Page
BKONDEL
ON|OFF on Packet Determines the way the screen is updated
when a character is deleted in the
command mode.
6-19
BLP
ON|OFF on Packet Allows Host Mode operation 6-20
BTEXT
text blank Packet Specifies the text of the beacon packet. 6-21
BUDLIST
ON|OFF off Packet Determines if the packets listed in
LCALLS are to be displayed.
6-22
BUF
n 0-9 CW/RTTY/ Allows addressing of the ten user ASCII
programmable memories.
6-22
BUFKEY
nnn 9 CW/RTTY/ Allows the user to transmit the ASCII
buffer without using the (CTRL-T).
6-23
BUFTIME
n 0 CW Used to transmit buffer 0 when it is a non-
zero value at the set interval.
6-23
BWNL
ON|OFF off AMTOR Causes the MFJ-1278B to transmit when
it receives a <CR>.
6-23
CALIBRA
-- I-command All Used to transfer the control to the modem
calibration routine.
6-24
CALSET
n 0 All Specifies the count setting for use by the
calibration routing.
6-24
CANLINE
n $18 (^x) Packet Changes the cancel-line input editing
command character.
6-25
CANPAC
n $19 (^Y) Packet Changes the cancel-packet input editing
command character.
6-26
CBELL
ON|OFF off Packet Sends a bell tone through the computer or
terminal speaker when a packet
connection is made.
6-27
CBell
ON/OFF OFF Pactor Sends a bell through the computer
terminal speaker when a Pactor connect is
established.
6-27
CCITT
ON|OFF on RTTY Determines whether U.S. standard or the
internationally recognized character set is
used.
6-28
CHANGE
- I-command AMTOR Switches from receiver to transmitter in
AMTOR mode A "ARQ".
6-28
CHAT
- I-command M-Packet Allows SYSOP to break onto the
mailbox's connected link.
6-28
CHECK
n 30 Packet Sets a connection timeout. 6-29
CHECKV1
ON|OFF off Packet Enables the automatic idle-link-
disconnect feature for AX.25 L2V1
connections.
6-29
CHObell
ON/OFF on Pactor Sends a bell tone to the computer or
terminal when a Pactor changeover is
done.
6-30
CHOChar
nnn 25 Pactor Designates the Pactor changeover
character.
6-30
CMDchr
nnn $03 Pactor Deisgnates the Pactor return to command
mode character.
6-30

Table of Contents

Related product manuals