149148
Represent that there is no energy flowing.
Standby Mode
When the engine speed is lower (<1,800
r/min), and the 48V battery capacity is greater
than 40%, the driver speeds up at full
accelerator (opening >70%). The system
enters the assist power mode to improve the
vehicle acceleration performance. When the
engine speed is greater than 2,000 r/min, exit
the assist power mode.
The assist power mode will also be enabled
under other conditions to reduce the fuel
consumption.
Assist Power Mode
When the vehicle speed is greater than 20
km/h during sliding and braking, without
depressing the clutch, the system can recover
a part of braking energy to store in the 48V
battery pack, improving the fuel economy of
the vehicle.
Energy Recovery Mode
DRIVING AND CONTROLS
Your vehicle may be equipped with a
Continuous Variable Transmission (CVT). A
C V T c a n c o n t i n u o u s l y c h a n g e t h e
transmission ratio, which is equivalent to
having innumerable gears, making gear shifting
smoother.
Automatic Transmission
Continuous Variable
Transmission (CVT)
Instruction for use:
1. Before starting the engine, depress the
brake pedal firstly to confirm that the
transmission gear lever is at the P gear, and
then the engine can be started.
2. Depress the brake pedal and then engage
gear after you start the engine.
3. Continuously depress the brake pedal after
you engage gear, release the electronic
parking brake, and release the brake pedal
after you are ready to start the vehicle.
4. After the brake pedal is released on
smooth pavement, the vehicle will start
running automatically and slowly with the
accelerator pedal not depressed.
5. It is forbidden to coast in neutral gear
d u r i n g d r i v i n g . O t h e r w i s e , t h e
transmission will be damaged or an
accident will occur.
Selector Lever
There is a locking button on the gearshift to
prevent the wrong choice of P or R in other
gears.
Do not press the button during the driving
process. Press this button only when the
vehicle is stationary and you intend to put it in
either P gear or R gear.
DRIVING AND CONTROLS