MG Hector User Manual

161160
If the battery is excessively low, EPB will
fail to be applied or released normally. If
the condition above exists, please charge
the battery. We recommend you contact
the MG Authorised Service Center for
solution.
Note
Specialized equipment and technologies
are required for EPB brake lining
replacement. Please do not have it
repaired by yourself or at a maintenance
shop rather than the Service Center.
Otherwise, the EPB system may get
damaged. If the EPB system components
have been overhauled, they are not
warranted for maintenance.
Note
the vehicle in situ (whether on a downhill or
uphill pavement or on flat ground), at the time
there is no need to draw back EPB to park.
If the driver depresses the accelerator and
releases the clutch to start the vehicle within 5
min, the hydraulic pressure in the brake
system will be automatically released and the
parking will be released, so as to start the
vehicle. 5 min later, it will automatically switch
to the EPB caliper to clamp and park, and the
hydraulic pressure in the brake system will be
released. Start and shutdown of AVH can be
memorized. If AVH is in the on / off state when
the power is off last time, AVH keeps in the
corresponding state when the power is on
next time.
Automatic Vehicle Hold (AVH) Switch*
When the engine has been in operation, the
driver’s safety belt is tightened, and the
driver’s side door has been closed, you have to
press the AVH switch, and the background
lamp on the switch illuminates to activate the
AVH function.
Afterwards, if following conditions are met,
the AVH working indicator on the instrument
illuminates. The parking brake will function
and the brake system applies the braking force
to park the vehicle in situ.
AVH Conditions (AVH Function Activated
Firstly):
1. The vehicle is motionless and the engine is
running.
2. The brake pedal is depressed to a degree
(brake hydraulic pressure > 4 bar).
3. The driver's seat belt is buckled and the
driver's side door is closed.
Other Conditions (They Shall be
Satisfied Simultaneously):
1. No fault exists on the system.
2. EPB has been released.
Automatic Vehicle Hold (AVH) *
The vehicle provided with EPB has the AVH
function.
The driver depresses the brake pedal to stop
the vehicle after the function is activated, or the
driver depresses the brake pedal when the
vehicle is motionless and the engine idles. After
the brake pedal is released, the hydraulic
pressure in the brake system will be kept to park
DRIVING AND CONTROLS
If you use any incorrect fuel, the engine
and the catalytic converter will get
seriously damaged. Always use the fuel
suitable for your vehicle.
For the purpose of safety, the fuel tank,
pump and pipe must be grounded
correctly. The static electricity will ignite
vapor included in the gasoline. You will
get burnt and the vehicle will get
damaged.
Caution
The fuel is one of flammables or
explosives.
Smoking is prohibited. Keep away from
open flames, sparks and smoking
materials. If gasoline catches fire, serious
burns will be caused and your vehicle will
get damaged.
I f y o u s m e l l f u e l o d o r s , p l e a s e
immediately ask MG Authorised Service
Center to repair according to the fault
cause.
Dangers
3. The accelerator pedal has not been
depressed (opening < 2%).
How to Manually Release Automatic
Parking Brake After AVH?
Confirm that the ignition switch is at the ON
position, depress the brake pedal, and press
the EPB switch. The AVH working indicator
goes out and the automatic parking brake is
released.
Automatic Release After AVH
You do not have to manually press the EPB
switch to release when starting the vehicle
next time after AVH. Automatic release will
be done when the system detects that you are
going to start the vehicle.
Operate the engine, engage gear (drive gear or
reverse gear), and the driver’s safety belt is
tightened and the driver’s side door has been
closed. Depress the accelerator and release
the clutch. After the vehicle start conditions
are met, the parking brake will be released
automatically.
Fuel Suggestions
Fill GB 91# gasoline for vehicle or gasoline
with the equivalent standard No., or gasoline
with a higher standard No. Using the fuel with
an extremely low octane value will reduce
power and torque of the engine, and increase
the consumed fuel volume.
Do not Use Methyl Alcohol
Do not use the fuel containing methyl alcohol
on the vehicle. This fuel will reduce the vehicle
performance and damage the fuel system
components.
Driving in Other Countries
When driving your vehicle in other countries:
Ÿ Please follow all registration and insurance
regulations.
Ÿ Confirm that the country can provide
proper fuel.
Fuel
DRIVING AND CONTROLS

MG Hector Specifications

General

Brand	MG
Model	Hector
Category	Automobile
Language	English