Radio Tuning
103
3
Waveband scan
Waveband scanning enables you to listen to all receivable stations
on the selected waveband for between 5 and 30 seconds each.
To start scanning: Press the MENU button (4) for two seconds
(‘SCAN’ is displayed briefly, followed by the frequency or station
name flashing).
To stop scanning: Briefly press the MENU button again.
NOTE: The scan time can be adjusted to suit your requirements (see
‘SCANTIME’ in ‘MENU CONTROL FUNCTIONS’,
page 110).
MONO/STEREO
Whenever the FM waveband is selected, the radio automatically
reproduces stereo sound, provided a suitable signal is available.
However, if a signal becomes too weak for good stereo reception,
only mono sound is produced until the signal strengthens
sufficiently for stereo sound reproduction.
To Next Page
Loading...
Need help?
General
