Radio Tuning
105
3
TRAVELSTORE
Travelstore operates on the FM waveband only and enables you to
rapidly tune and store the six strongest FM radio signals in a single
operation. This facility is particularly useful if you are in an
unfamiliar area and have little knowledge of local transmitter
frequencies.
Programming Travelstore
Press and hold the waveband selector (1) - the radio mutes, an
audible ‘beep’ will sound (if ‘BEEP ON’ has been selected - see
‘MENU CONTROL FUNCTIONS’, page 110) and the display
shows ‘T-STORE’.
Travelstore scans the FM waveband to find the six strongest
frequencies and then stores them in the FMT memory bank in
order of signal strength. Radio sound is restored once the
operation is complete.
If Travelstore is unable to locate and store six stations, the display
shows (‘-----’) for any unoccupied pre-sets, and the radio reverts
to the last recalled pre-set frequency on the FMT waveband.
NOTE: Travelstore overwrites any stations already stored on the FMT
memory bank.
NOTE: If Travelstore is programmed with traffic information active, then
programming will be limited to those stations capable of providing traffic
information. In some areas this could severely limit the frequencies available
to Travelstore and, for this reason, it is recommended that traffic
information is switched off before Travelstore is programmed.
NOTE: Station frequencies can also be stored manually onto pre-sets in
the FMT memory bank (see ‘RADIO PRE-SET BUTTONS’,
page 104).
Operating Travelstore
To tune to a Travelstore frequency, select the FMT waveband
then press the pre-set button (2) of your choice. The display will
initially indicate the selected pre-set number and then display the
frequency or station name and FMT waveband e.g: ‘FMT 89.5’.
AS0045
TRAF.RDSBND.TS
123 64 RPT 5 MIX
AUDIO X-BASS
SRC
MENU
D
M
S
2
1
To Next Page
Loading...
Need help?
General
