14
Locks & Alarm
ENGINE IMMOBILISATION OVERRIDE
(Emergency key access code)
If the handset is lost or fails to operate, the engine can be
remobilised by using the starter key in the driver’s door lock to
enter the numerical values of the four digit emergency key access
code (recorded on the Security Card).
With the starter switch turned off and the driver’s door locked,
enter the code as follows:
1. Insert key into driver's door lock and to enter the FIRST digit
of the code, turn the key to the UNLOCK position the number
of times indicated by the first digit of the code. For example, if the
first digit is 4, turn the key 4 times.
Ensure the key is FULLY returned to the centre position after each
turn of the key.
2. Turn the key to the LOCK position the number of times
indicated by the second digit of the code. Remember, the key
must be FULLY returned to the centre position after each turn of
the key.
3. Turn the key to the UNLOCK position the number of times
indicated by the third digit of the code, returning the key to the
centre position each time.
4. Turn the key to the LOCK position the number of times
indicated by the fourth digit of the code, returning the key to the
centre position each time.
If the correct code has been entered: the alarm indicator light on the
instrument panel will stop flashing and illuminate for 1 second. A
5 minute time delay will commence, during which the engine will
remain immobilised.
DO NOT lock or unlock the doors using the remote handset or
key during the 5 minute delay. If this occurs, the emergency key
access code will need to be re-entered. If the car needs to be
secured, use the door sill locking buttons to lock the doors,
ensuring that the remote handset or key is not left inside the car.
HB0517
IMPORTANT
Each turn of the key must be undertaken with care and precision.
Ensure the key turns through the FULL extent of its travel and is
FULLY returned to the centre position after each turn.
To Next Page
Loading...
Need help?
General
