To Next PageTo Next Page
Need help?Do you have a question about the Mi-T-M HEG Series and is the answer not in the manual?
Explains safety alert boxes, signal words (DANGER, WARNING, CAUTION), and safety alert symbols.
Details hazards, consequences, and prevention measures for explosion and fire risks.
Outlines hazards, consequences, and prevention for asphyxiation risks.
Covers electrical hazards, potential consequences, and prevention measures.
Details dangers of high-pressure spray penetration and cutting injuries.
Explains dangers of touching hot components and prevention.
Covers hazards of unit bursting due to freezing or malfunction and prevention.
Addresses injury risks from moving parts and safety precautions.
Details risks of bodily injury from detergents, debris, and loss of balance.
Lists and describes components of the HEG-Series pressure washers.
Lists and describes components of the HEG-High Volume Series pressure washers.
Guidelines for selecting a safe and appropriate location for the pressure washer.
Safe methods for lifting and moving the pressure washer using a forklift.
Details electrical connection and grounding requirements for safe operation.
Instructions and recommendations for gas line installation and safety.
Guidelines for proper ventilation of combustion gases and air intake.
Specifies requirements and procedures for connecting the water supply.
Instructions for connecting the high pressure hose to the gun assembly.
Checks to ensure proper installation and gas pressure settings.
A checklist of critical items to verify before operating the gas-fired unit.
Advises on proper clothing and safety gear for operating the unit.
Essential checks to perform before starting the unit, including gas smell and oil level.
Explains how to select and attach different spray nozzles based on their fan angle.
Step-by-step guide on how to safely connect and disconnect nozzles from the lance.
How to adjust the dual lance for high or low pressure spray patterns.
Procedure to flush the system before initial start-up to remove debris.
Step-by-step guide for operating the pressure washer in cold water mode.
Instructions for operating the unit in hot water mode, including safety precautions.
Guidance on using mild detergents for cleaning, including safety and procedures.
Steps to safely shut down the pressure washer after use.
Information on controlling the unit from remote workstations.
Explanation of the automatic shutdown feature.
Details on the automatic start/stop functionality.
How to utilize the 250°F steam output option.
Procedure to flush the PLC system before initial start-up.
Step-by-step guide for operating the PLC unit in cold water mode.
Instructions for operating the PLC unit in hot water mode.
Guidance on using detergents with the PLC unit.
Steps to safely shut down the PLC unit after use.
Explanation of the automatic start/stop functionality for PLC units.
How the timer lockout feature prevents unwanted automatic starts.
Information on controlling PLC units from remote workstations.
How to use the 250°F steam output option on PLC units.
How to identify and fix leaks in the system promptly.
Maintenance for quick couplers, including o-ring replacement.
Information on nozzle wear, pressure loss, and replacement criteria.
Instructions for changing pump oil and checking its level.
Procedures for checking and adjusting belt tension and alignment.
Procedure for removing mineral deposits from the heat exchanger coil.
How to test voltage and amperage, or when to use a service technician.
Method to remove water using compressed air for winterization.
Method using antifreeze solution to protect the unit from freezing.
Details common symptoms, their likely causes, and recommended solutions.
Lists conditions and parts not covered by the manufacturer's warranty.
General| Brand | Mi-T-M |
|---|---|
| Model | HEG Series |
| Category | Pressure Washer |
| Language | English |
