4 ACDC200LCD
Your Machine’s Condition
• Check ground cable, power cord and welding cable to be sure the insulation is not
damaged. Always replace or repair damaged components before using the welder.
• Check all components to ensure they are clean and in good operating condition
before use.
Use of Your Machine
• Do not operate the welder if the output cable, electrode, TIG torch, wire or wire
feed system is wet. Do not immerse them in water. These components and the
welder must be completely dry before attempting to use them.
• Follow the instructions in this manual.
• Keep welder in the o position when not in use.
• Connect ground lead as close to the area being welded as possible to ensure a
good ground.
• Do not allow any body part to come in contact with the welding wire/ller if you are
in contact with the material being welded, ground or rod/electrode from
another welder.
• Do not weld if you are in an awkward position. Always have a secure stance while
welding to prevent accidents. Wear a safety harness if working above ground.
• Do not drape cables over or around your body.
• Wear a full coverage helmet with appropriate shade (see ANSI Z87.1 safety
standard) and safety glasses while welding.
• Wear proper gloves and protective clothing to prevent your skin from being
exposed to hot metals, UV and IR rays.
• Do not overuse or overheat your welder. Allow proper cooling time
between duty cycles.
• Keep hands and ngers away from moving parts and stay away from the drive rolls.
• Do not point welding torch at any body part of yourself or anyone else.
• Always use this welder in the rated duty cycle to prevent excessive heat and failure.
To Next Page
Loading...
