Michigan Welding ACDC200LCD - Installation and Connections

12 ACDC200LCD
INSTALLATION
Machine Setup
Earth
Clamp
Positive
Socket
Foot Pedal
Socket
Negative
Socket
TIG
Torch
Foot
Pedal*
*additional extra
TIG torch gas
connection
Power Requirement
AC single phase 240V, 50/60 Hz fused with a suitable time delayed fuse or circuit
breaker is required
WARNING
!
High voltage danger from power source! Consult a qualied
electrician for proper installation of receptacle. This welder must be
grounded while in use to protect the operator from electrical shock.
Do not remove grounding prong or alter the plug in any way. Do
not use any adapters between the welder’s power cord and the
power source receptacle. Make sure the POWER switch is OFF
when connecting your welder’s power cord to a properly grounded
240Vac, 50/60Hz, single phase power source.
Extension Cord
It is strongly recommended that an extension cord should not be used because of the
voltage drop they produce. This drop in voltage can aect the performance of the welder.
If you need to use an extension cord must use conductors of at least 6mm
2
and less than
8m length.