11
©2020 Micro-Air, Inc. May 1, 2020 Revision 1.04
Note:
(1) Heating modes available are based on the system the thermostat is connected to. Only available
heating modes will be displayed.
Settings
the displayed temperature by up to 10°F (5.5°C).
Adjust the furnace or Aqua system temperature change to either 1° or 2°.
Use WPS to connect to a router or connect the display to an account.
View the system heating options.
Select the day or night screen brightness.
Set the display brightness for day or night.
Reset the display to factory defaults.
Return to the last screen.
Automatic selection between low and high fan speeds. Fan is off at setpoint, on low
speed within 5°F (2.8°C) of set point, and high otherwise.
Home mode. Thermostat operate
based on selected set point.
Away mode. Thermostat operates heating and/or cooling based on the upper and
lower limits the user sets.
Schedule mode. Operates like the home mode but will change the set point at specific
times of day set in the schedule.
To Next Page
Loading...
Need help?
General
