MicroCool IBEX Series - Page 20

IBEX 8 Nozzle SMALL FRAME_June 2020 June 20 Page 20 of 41
Inlet Pressure Fault
• Inlet water pressure dropped below safe
operating limit
• 30 second restart delay is in process
• If water pressure is restored within 30
second delay, pump will start up and
operate normally
• If water pressure is not restored, another
30 second delay will start
• Pump will attempt to restart 4 times
before the system locks out on a fault
Frequency Inverter Fault
• Pump system has faulted on VFD fault
• 30 second restart delay is in process.
• If VFD fault is cleared within 30 seconds
pump will restart and operate normally.
• The pump will attempt to restart 4 times
before
the system locks out on a fault.
Service Oil Change
• Pump requires service.
• Change pump oil – (Please dispose of
used oil in accordance with local laws
and regulation).
• Press F4 key 3 times consecutively to
reset
Manual Disabled
• F1 button disabled
• Settings to enable
Service UV Lamp
• Change UV lamp
• Press F4 three times to rest.