Microgate SyncLink GT2 - Serial Connector Pin Assignments

SerialConnectorPinAssignments
TheserialconnectorsontheendofeachbanchoftheY‐cableareDB‐25(25pins)maleconnectors.The
assignmentofsignalstotheconnectorpinsiscontrolledbytheinterfaceselectionjumpersonthecard.
ForinterfacetypesthatuseaconnectordifferentthanDB‐25anadaptercablepurchasedfrom
MicroGateisrequired.Thefollowingsectionsdescribethejumper settingsandcablesforeach
supportedstandard.






