22
5.2. Displaying stored results
Press the MEMORY button x to display the stored readings. After all the segments
in the display have been shown, an average value of all the measurements in the
selected memory is displayed. This average is indicated by “ ”.
When the MEMORY button x is pressed again, the individual readings (switching
between systolic, diastolic, pulse and date/time) of the last measurement stored are
displayed. If this measurement was taken in the 3MAM procedure, bk is
displayed. If an arrhythmia was detected during the measuring
process, the arrhythmia symbol
will be displayed, but not flashing.
Press the MEMORY button x again to move backwards through the stored readings.
If you do not press any buttons for approx. 1 minute, the device automatically switch-
es back to standby mode.
5.3. Deleting a measurement
Select the entry for the measurement you want to delete. Press and hold the START
button w for approx. 10 seconds until the memory symbol aq flashes. Confirm your
deletion request by pressing the MEMO button x. “ ” appears briefly on the
display and 2 short beeps sound. The entry you selected has been deleted. The
display returns to standby mode.
5.4. Deleting memory
The data can be deleted from the memory selected by pressing and holding the
MEMORY button x for about 7 seconds. After 7 seconds, the display v shows
“ ” ( CLEAR ) which indicates that all data will be deleted.
Confirm your deletion request by pressing the MEMO button x again. Three short
beeps sound during the procedure.
6. Miscellaneous
6.1. Care and maintenance
• Remove the batteries before cleaning the unit.
• Never use strong detergents or hard brushes.
• Clean the unit with a soft cloth, moistened with mild soapy water. Do not let water
enter the unit. After cleaning, only use the unit when completely dry.
• Remove the batteries from the unit if you do not wish to use it for an extended
period of time, otherwise there is a risk of battery leakage.
• Do not expose the unit to direct sunlight, and protect it from dust and moisture.
• Only inflate the cuff when it is in position around the upper arm.
To Next Page
Loading...
Need help?
General
