Page 11
7). How to set the address of indoor monitor.
The default address is Room1. Optional Room1～Room4. The master monitor which
connects to door station directly,
should be set as Room1. If the system has 2 or more than 2 indoor monitors, can’t set a
same address in 2 monitors, or the system can’t work normally & that option will caution
in red color.
You can use SYSTEM SETTINGS menu to turn “DO NOT DISTURB” function on or off.
When turn on this function, the indoor monitor shall not chime when someone calls to it.
8). How to enter system setting?
At standby status, users can long press to enter system settings menu.
10). How to enter advanced settings?
In the models that are not installed in a multi-apartment system, users can enter
advanced setting by restarting the monitor, and long press at welcome screen.
In the models that are connected in a multi-apartment system, there isn’t a welcome
screen after restarting monitor. The indicator shall flicker a few times after restarting
the monitor, long press , then the monitor shall enter advanced settings menu.
9).“Don’t disturb” function
ADVANCED SETTING
NOV 12 2014 10:10:22
VCOMDC
140
01S
ENABLE
UNLOCK TIME
MONITOR UNLOCK
To Next Page
Loading...