Microsemi SyncSystem 4380A - Page 21

DOC 4380A
4380A O & M Manual
13
098-00723-000– Jul 2017 Revision 4.0 SyncSystem 4380A O&M Manual
[OK] 2015-08-05T15:42:42Z
B. Set the latitude for the antenna using the latitude command.
4380A>latitude 38.46627893094
or
4380A>latitude 38.46627893094N
NOTICE
Note: Default is [N]orth. If you are in the southern hemisphere make sure there is an [S]outh
after the latitude or a (-) before the latitude.
4380A>latitude -38.46627893094
or
4380A>latitude 38.46627893094S
C. Set the longitude for the antenna using the longitude command.
4380A>longitude 77.44086542274004
or
4380A>longitude 77.44086542274004E
NOTICE
Note: Default is [E]ast. If you are in the Western hemisphere make sure there is an [W]est after
the latitude or a (-) before the latitude.
4380A>longitude -77.44086542274004
or
4380A>longitude 77.44086542274004W
D. Set the altitude for the antenna using the “altitude” command. Default value is ellipsoid height
meters. Users can specify the height in feet by using F after the value.
4380A>altitude 51.573999999999998
or
4380A>altitude 169.206037003 F
E. Verify the current settings are correct using the settings gps command or narrow it down further
with the settings gps:positioning:manual_position and settings gps:datum commands.
4380A>settings gps:positioning:manual_position
[altitude] 5.1573999999999998e+01
[latitude] 3.8466278930940000e+01
[longitude] -7.7440865422740004e+01
4380A>settings gps:datum
wgs84
[OK] 2015-08-05T15:43:31Z
The operator also has the option of setting the manual mode and entering all three parameters on the same
command line using the fix_position (current | lat, lon, alt) command.
4380A> fix_position 38.46627893094 -77.44086542274004 51.573999999999998